SRLY

  • Home
  • Store
  • Tutorials
  • Blog
  • My Cosplays
  • Prints
  • About Me
  • Contact/Book Me
  • Home
  • Store
  • Tutorials
  • Blog
  • My Cosplays
  • Prints
  • About Me
  • Contact/Book Me

Free Tutorials

ffx yuna braska summoner staff tutorial

4/7/2017

0 Comments

 
Picture
Measuring 63″ tall (exactly my height), it took 2 days to finish Yuna’s staff. I used 1/4″ thick plywood for the main staff head middle and 2mm thick craft foam to sandwich it in. The paper pattern shown in the picture is WITHOUT the blue areas. The pattern shown on the wood includes the blue areas. I used a broomstick for the staff’s base. I got lucky and bought one that’s already pointed at the end at Lowe’s hardware, but you could also sand the end of any broomstick to get the same effect.
​

We cut 1/4″ gap in the tip so that I could fit the staff head in between. After cutting the craft foam out, I made cuts at the bottom of the circle to fit around the broomstick (so the only thing inside the slit was the plywood.) The gold and silver rings are also made of craft foam. I might get a larger bell, but this one works for now. There’s a hole drilled at the bottom handle to thread the bell.
Picture
0 Comments

Your comment will be posted after it is approved.


Leave a Reply.

    Archives

    April 2019
    February 2019
    January 2019
    November 2018
    October 2018
    July 2018
    April 2018
    March 2018
    February 2018
    December 2017
    June 2017
    May 2017
    April 2017
    March 2017
    May 2016
    April 2016
    February 2016

    Categories

    All

Contact/About


© COPYRIGHT 2015. ALL RIGHTS RESERVED.